fabcam
03-09-2007, 03:35 PM
This thread will show some example of making 90 degree bends. If you haven't gone through the general rules of 3D, then do so: http://www.2020softwaresolutions.com/forums/showthread.php?t=48
ex 1.1
Lets start by making 12 x 15 "L" bracket in a couple of different planes.
1) Select the "1" from the "bend" selection list.
2) Enter a value of "12" to the front.
NOTE: The tri-star is located at the location where you are currently at. You are entering in the direction(s) and distance(s) from this point to your first bend.
http://www.2020softwaresolutions.com/images/support06.jpg
3) Select the "E" from the "bend" selection list.
4) Enter a value of "15" to the left.
NOTE: Again the tri-star is your current location and you are entering in the directions(s) and distance(s) from this point.
http://www.2020softwaresolutions.com/images/support07.jpg
ex 1.1
Lets start by making 12 x 15 "L" bracket in a couple of different planes.
1) Select the "1" from the "bend" selection list.
2) Enter a value of "12" to the front.
NOTE: The tri-star is located at the location where you are currently at. You are entering in the direction(s) and distance(s) from this point to your first bend.
http://www.2020softwaresolutions.com/images/support06.jpg
3) Select the "E" from the "bend" selection list.
4) Enter a value of "15" to the left.
NOTE: Again the tri-star is your current location and you are entering in the directions(s) and distance(s) from this point.
http://www.2020softwaresolutions.com/images/support07.jpg