fabcam
03-07-2007, 06:24 PM
Custom Part uses the center line of the material!
This is in comparison to the inside or outside of the material. If you know the outside or inside dimensions you will need to add or subtract 1/2 the material diameter for many cases and will need to do some quick trig or math for bends that don't line up to plane.
This is in comparison to the inside or outside of the material. If you know the outside or inside dimensions you will need to add or subtract 1/2 the material diameter for many cases and will need to do some quick trig or math for bends that don't line up to plane.