fabcam
03-07-2007, 02:59 PM
Start using Assembly without calibrating my die?
For the most part this is Ok. When you transfer a part back to 3D or XYZ it will bring in the information for your tool. If the tooling has been updated it will automatically catch this.
http://www.2020softwaresolutions.com/images/part_details01.gif
For the most part this is Ok. When you transfer a part back to 3D or XYZ it will bring in the information for your tool. If the tooling has been updated it will automatically catch this.
http://www.2020softwaresolutions.com/images/part_details01.gif