Bend-Tech EZ in-depth
Bend-Tech EZ in-depth
|
|
|
Results are what we describe as the information available to you for manufacturing the tube. The "Cut Length" is the length to cut the tube to. The chart shows A, Location and Angle. A is the design order, Location is where to mark the tube for bending and the Angle is the number of degrees to bend the tube.
"Cut Off" allows to add extra material to the end of the tube for post bending cutting. This is used largely for cutting to place one tube against another. In this example we added 2 to our value so the cut length grew by 4 and each bend was moved 2.
We can change the "Decimal / Fraction" fields to allow for tolerances of 1/4 to 1/32 and decimal places from 0 to 0.000. In this example we changed the fractions to 1/8.
Now we changed to decimals and 3 places.
We have 3 settings which can be used for the dimension location; Start, End & Center. Typically a rotary draw bender will use start, a rotary compression bender will use end and a center compression will use center.
This is an example of a center compression bender. Some customers have been known to use the center choice for sheet metal fabrication. |
|
Send mail to webmaster@2020softwaresolutions.com with
questions or comments about this web site.
|
